Show Me Tell Me Driving Quiz
Questions: 16 · 10 minutes
1. What is the safe way to check the engine-coolant level?
Rely only on the temperature gauge because coolant reservoirs have no level markings
Remove the pressure cap immediately after a journey and check whether steam escapes
Check the coolant by touching the radiator hose while the engine is running
When the engine is cool, check the level against the minimum and maximum marks on the expansion or header tank
2. How can you check that the headlights and rear lights are working before a journey?
Start the engine and rely on the absence of a general warning light
Operate the appropriate light switch, then walk around the stationary vehicle to check the lamps, using reflections or assistance if needed
Flash the main beam once and assume every exterior lamp shares the same circuit
Press the brake pedal because it activates all front and rear lights
3. After starting the car, the anti-lock braking system warning light remains illuminated instead of going out. What does this indicate?
The anti-lock system is actively improving grip because the road is wet
The parking brake has been applied correctly
The brake lights are switched on continuously
The anti-lock braking system may have a fault that needs attention
4. A tyre looks slightly soft before a long journey. What is the best way to establish the correct pressure?
Inflate it until its sidewall feels as firm as the other tyres
Use the maximum pressure moulded on the tyre sidewall for every journey
Set every tyre to the same pressure, including the spare, regardless of vehicle load
Find the manufacturer’s pressure specification in the handbook or vehicle label and use a reliable gauge, preferably when the tyres are cold
5. Which head-restraint position generally offers the most effective protection?
The top of the restraint is level with the base of the neck and tilted away from the head
The rigid part is at least as high as the eyes or top of the ears and positioned close to the back of the head
The restraint is at its lowest setting so it supports the shoulders
The restraint touches the top of the head but leaves a wide gap behind it
6. During a safe pre-drive check, what should you expect when testing the footbrake?
The pedal should not feel excessively spongy or slack, and the car should not pull to one side when braking
The steering should become heavier whenever the pedal is pressed
The pedal should sink steadily to the floor if the engine is running
The parking-brake warning light should stay illuminated throughout the journey
7. You are asked to explain how you would check the power-assisted steering before moving off. Which method is appropriate for many cars?
Turn the steering wheel fully from side to side with the engine off and listen for tyre noise
Drive at speed and release the wheel briefly to see whether the car stays straight
Apply gentle pressure to the steering wheel while starting the engine; a slight movement should indicate that assistance is operating
Check the steering only by looking for a warning message on the dashboard
8. The windscreen begins to mist while you are driving. Which response demonstrates the demisting controls appropriately?
Use the rear fog-light switch until the windscreen clears
Open the bonnet release slightly to increase airflow through the car
Direct suitable airflow toward the windscreen, adjusting fan speed and temperature or air conditioning as needed
Turn off the ventilation system so outside moisture cannot enter
9. Under the bonnet, how would you check the brake-fluid level?
Identify the brake-fluid reservoir and confirm the level is between its minimum and maximum markings
Check that the fluid is the same colour as the engine oil
Open the reservoir and fill it to the cap whenever the engine is cold
Press the brake pedal repeatedly and watch for fluid beneath each wheel
10. You are checking the rear fog light while the car is stationary. Which procedure is appropriate?
Operate the rear fog-light control with the required exterior lights on, identify its warning indicator and verify the lamp; use it on the road only when visibility is seriously reduced
Press the hazard-warning switch and look for two red dashboard arrows
Select reverse gear and check for a white light at the back
Turn on the interior light and check whether the rear number plate becomes brighter
11. How should you demonstrate that the horn works before setting off?
Check for a horn-shaped dashboard light without pressing the control
Wait until the vehicle is moving, then sound it near another road user
While stationary, briefly operate the horn control while considering whether it could disturb or alarm others
Hold the horn continuously so its volume can be assessed
12. You need to check the brake lights while you are alone. What is a suitable method?
Press the brake pedal and assume the lights work if the pedal feels firm
Switch on the hazard lights because they use the same bulbs in every vehicle
Use reflections in a window or garage door, or position a suitable aid so you can verify that the lights illuminate
Turn on the rear fog lights and check whether their dashboard symbol appears
13. While driving, you are asked to show how you would clean the front windscreen. What confirms that you have used the correct control?
The rear window heats while the front wipers remain still
Washer fluid sprays onto the windscreen and the wipers clear it, with the control used only when it is safe
The headlights change from dipped beam to main beam
The ventilation fan increases to its highest setting
14. How should you check that the engine has enough oil using a dipstick?
Check whether oil reaches the top of the dipstick tube while the engine is running
With the car level and the engine off, remove and wipe the dipstick, reinsert it fully, then confirm the oil is between the marked limits
Remove the oil filler cap and judge the level by looking into the opening
Squeeze the dipstick handle and check whether the oil warning light comes on
15. While driving, the temperature warning appears and there are signs that the engine may be overheating. What should you do?
Stop in a safe place, switch off the engine, allow it to cool and seek appropriate assistance; do not open a pressurised coolant cap while hot
Immediately remove the coolant cap while the engine is hot to release pressure
Pour cold water over the engine without stopping it
Continue at a higher speed so more air passes through the radiator
16. When checking a car tyre, which finding meets the usual UK legal tread-depth requirement for a passenger car?
Any visible tread pattern, provided the tyre-pressure warning light is off
At least 1.0 mm across any visible part of the tread, provided both outer edges are deeper
At least 2.0 mm on the outer edge only, regardless of the centre of the tyre
At least 1.6 mm across the central three-quarters of the tread and around the entire circumference, with no dangerous cuts or bulges